The problem of fault belt machine

The problem of fault belt machine
We will have some more or less mechanical failure, in the use of belt machine production process, so, when we encounter problems when the fault belt machine, and how to solve these problems?
Abrasive belt machine
First, analysis of fault belt machine:
1, some vibration problems: belt machine hanging belt, start the machine, the machine is not fixed a big shock, would "run around"! What is the reason? The main rotating wheel balance wheel is not good! A rubber wheel and a belt wheel of a motor, a rotary wheel three the accuracy is not good, the balance is not good, the machine shake is not good! Another reason for supporting wheel parts with the gap is too large, resulting in relative movement between parts, vibration. Then motor fixed is not good, also produce vibration.
2, noise: noise is mainly base and rigid supporting parts, with parts of the gap is too large (some processing equipment factory is very poor, very poor, coupled with poor quality awareness, the manufacturing of the parts is very poor, almost no tolerance requirements!), the causes of low quality bearings, belt speed fast etc..
3, life: some belt machine with not how long it is broken, there are several reasons: the adjustment part of the gray cast iron, carbon steel casting without using 45#, or without heat treatment, the quality is not good, bearing lubrication is not good, no spindle modulation of heat treatment, or hard or too high (low degree of processing low abrasion, high breakage, bad quality of motor).
4, the use of the problem: the size of the machine, the design of the structure is very critical, better structure and the size of the joint is the key to polishing the efficiency of workers.
If there is any problem using abrasive belt machine, please contact customer service!